---
title: "Accelerometer -25..25 g"
url: "https://cma-science.com/product/accelerometer-25-25-g/"
type: "product"
published: "2025-07-16T13:21:31+01:00"
modified: "2026-09-22T10:01:19+01:00"
author: "Tom van Raaij"
---

The measurement range of the High g Accelerometer allows measuring accelerations produced during collision experiments but dropping the Accelerometer on a hard surface from even a few centimeters can produce acceleration of a hundred g’s. Accelerations above ± 50 g will damage the sensor.
 The High g Accelerometer is delivered with two pieces of Velcro tape, which can be used to mount the round box of the Accelerometer on a moving object.
 The Accelerometer should be mounted in the appropriate orientation for an experiment (so that its axis is in the direction of interest).

Technical specifications:

- Measurement range: -25.0 g .. 25.0 g or -245 m/s2 .. 245 m/s2
- Resolution: 0.02 g
- Accuracy: 0.2 g
- Maximum measurement frequency: 100 kHz (CoachLab II+, WiLab) / 1 MHz (VinciLab 2)
- Warranty: 3 years

Technical specifications of the sensor are described in the product manual, see downloads.

**The Accelerometer can be used for a wide variety of experiments, both inside and outside the classroom**:

- Measuring acceleration during a collision
- Measuring acceleration as it moves in a horizontal circle and/or vertical circle
- Measuring accelerations during body movements: put the Accelerometer under your belt buckle, and jump up and down, land both with your knees flexed and with your knees held more stiff
- If you have the CMA VinciLab data-logger you might measure acceleration on elevators, on amusement park rides, on playground apparatus, in a car, during bungee jumps, etc.
- To measure acceleration in two or three directions mount two or three Accelerometers at right directions.

**DO NOT** drop the sensor directly onto a solid surface this will damage the sensor.

The High g Accelerometer can be directly connected to analog BT inputs of the CMA interfaces.
 **Attention:** The sensor cable BT – IEEE1394 needed to connect the sensor to an interface is **not** supplied with the sensor and has to be purchased separately (BTsc_1 or BTsc_1Short).
